LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Lubrication System (2GR-FKS) - Service Information (Except Hybrid)) >> Oil Level Sensor >> Installation [06/2017 - ] >> Procedure

Installation [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ENGINE OIL LEVEL SENSOR 
    1. Install the engine oil level sensor to the oil pan sub-assembly with the 2 nuts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Install a new clip to the engine oil level sensor.
  2. INSTALL OIL STRAINER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 54

  3. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 55

  4. REMOVE ENGINE ASSEMBLY FROM ENGINE STAND 

    Refer to INSTALLATION [06/2017 - 10/2020] , or refer to INSTALLATION [10/2020 - ]

scientia non olet · About LEMON Manuals