Inspection [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT ENGINE OIL LEVEL SENSOR
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - Body ground ON Below 1 Ω OFF 10 kΩ or higher *a Component without harness connected
(Engine Oil Level Sensor)*b Engine Oil Level Sensor Body *c ON *d OFF If the result is not as specified, replace the engine oil level sensor.
- Measure the resistance according to the value(s) in the table below.