LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Emission Control System (2GR-FKS) - Service Information (Except Hybrid)) >> Fuel Tank Cap >> Inspection [06/2017 - ] >> Procedure

Inspection [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT FUEL TANK CAP ASSEMBLY 
    1. Visually check that the fuel tank cap assembly and gasket are not deformed or damaged.
      GTY444169Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Gasket

      If the result is not as specified, replace the fuel tank cap assembly.

    2. Confirm that ID mark V is printed on the fuel tank cap assembly.
      GTY768200Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a ID Mark
      WARNING:

      Make sure to use a fuel tank cap assembly that has the same ID mark, or a malfunction may occur in the fuel system.

scientia non olet · About LEMON Manuals