LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Battery / Charging System (2GR-FKS) - Service Information (Except Hybrid)) >> Generator >> Removal [06/2017 - 10/2020] >> Procedure

Removal [06/2017 - 10/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [06/2017 - 09/2019] , or refer to PRECAUTION [09/2019 - 03/2020] , or refer to PRECAUTION [03/2020 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [06/2017 - 08/2018] , or refer to INITIALIZATION [08/2018 - 09/2019] , or refer to INITIALIZATION [09/2019 - 03/2020] , or refer to INITIALIZATION [03/2020 - 10/2020]

  3. REMOVE RADIATOR ASSEMBLY 

    Refer to REMOVAL [06/2017 - 10/2020]

  4. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 19 [08/2018 - 10/2020]

  5. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [06/2017 - ]

  6. REMOVE GENERATOR ASSEMBLY 
    1. Open the terminal cap.
      GTY768401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut and disconnect the wire harness from terminal B.
    3. Remove the 2 bolts.
    4. Disconnect the generator assembly connector.
      GTY774661Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disconnect the compressor assembly with magnetic clutch connector.
    6. Disconnect the camshaft timing oil control solenoid assembly connector.
    7. Disengage the 3 wire harness clamps and remove the wire harness clamp bracket.
    8. Remove the 2 bolts and generator assembly bracket.
      GTY768400Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Remove the 2 bolts and generator assembly.
      GTY768399Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals