Components [06/2017 - ]
WARNING: This page is about a different variant/trim than selected.
| Callout | Description | Callout | Description |
| *1 | GENERATOR ASSEMBLY | *2 | WIRE HARNESS CLAMP BRACKET |
| *3 | GENERATOR ASSEMBLY BRACKET | *4 | V-BANK COVER SUB-ASSEMBLY |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | N*m (kgf*cm, ft.*lbf): Specified torque |
| Callout | Description | Callout | Description |
| *1 | GENERATOR BRUSH HOLDER ASSEMBLY | *2 | GENERATOR COIL ASSEMBLY |
| *3 | GENERATOR DRIVE END FRAME BEARING | *4 | GENERATOR PULLEY WITH CLUTCH |
| *5 | GENERATOR REAR END COVER | *6 | GENERATOR ROTOR ASSEMBLY |
| *7 | GENERATOR TERMINAL INSULATOR | *8 | GENERATOR DRIVE END FRAME |
| *9 | RETAINER PLATE | *10 | BEARING COVER PACKING |
| *11 | GENERATOR PULLEY CAP | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST | |
| • | Non-reusable part | - | - |