LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Starting System (2GR-FKS) - Service Information (Except Hybrid)) >> Relay >> Inspection [06/2017 - ] >> Procedure

Inspection [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT ST RELAY 
    1. Check the resistance.
      GTY329933Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the ST relay.

scientia non olet · About LEMON Manuals