LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Transfer Case - Service Information (Except Hybrid)) >> Transfer Assembly >> Removal [10/2020 - ] >> Procedure

Removal [10/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Toyota Camry, 2023 Toyota Camry, 2022 Toyota Camry, 2021 Toyota Camry, and 2020 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [10/2020 - ]

  2. REMOVE PROPELLER SHAFT HEAT INSULATOR 

    Refer to PROCEDURE - Step 19

  3. REMOVE NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY 
    1. Remove the 2 bolts and No. 1 propeller shaft heat insulator bracket sub-assembly from the transfer assembly.
      GTY934333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20

  5. REMOVE TRANSFER ASSEMBLY 
    1. Remove the 8 nuts and transfer assembly from the automatic transaxle assembly.
      GTY869846Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals