Installation [03/2020 - 10/2020]: Procedure
WARNING: This page is about a different car, the 2024 Toyota Camry, 2023 Toyota Camry, 2022 Toyota Camry, 2021 Toyota Camry, and 2020 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL TRANSFER ASSEMBLY
- For Type A:
- Clean the bolt holes.
- Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 6 nuts and 2 new bolts.
*a 17 mm Union Nut Wrench *b Torque Wrench Fulcrum Length - SST: 09961-00950
Specified tightening torque
Torque: 68.6 N*m (700 kgf*cm, 51 ft.*lbf)
HINT:
- Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Refer to PRECAUTION [03/2020 - ]
- When using a 17 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 40.2 N*m (410 kgf*cm, 30 ft.*lbf)
- For Type B:
- Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.
*a 17 mm Union Nut Wrench *b Torque Wrench Fulcrum Length - SST: 09961-00950
Specified tightening torque
Torque: 68.6 N*m (700 kgf*cm, 51 ft.*lbf)
HINT:
- Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Refer to PRECAUTION [03/2020 - ]
- When using a 17 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 40.2 N*m (410 kgf*cm, 30 ft.*lbf)
- Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.
- For Type A:
- INSTALL REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
- INSTALL NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY
- Install the No. 1 propeller shaft heat insulator bracket sub-assembly to the transfer assembly with the 2 bolts.
Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
- Install the No. 1 propeller shaft heat insulator bracket sub-assembly to the transfer assembly with the 2 bolts.
- INSTALL PROPELLER SHAFT HEAT INSULATOR
Refer to PROCEDURE - Step 13
- INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
Refer to INSTALLATION [03/2020 - 10/2020]