Caution / Notice / Hint
WARNING: This page is about a different car, the 2024 Toyota Camry, 2023 Toyota Camry, 2022 Toyota Camry, 2021 Toyota Camry, and 2020 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transfer case oil seal RH removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Replacement of automatic transaxle fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. | Refer to INITIALIZATION [03/2020 - ] |
| Front wheel alignment adjustment | Perform system variant learning and acceleration sensor zero point calibration. |
|
Refer to CALIBRATION [06/2017 - 10/2020]
*1 Refer to CALIBRATION [06/2017 - 10/2020] *2 |
*1: w/ Electric Parking Brake System*2: w/o Electric Parking Brake System