AWD Warning does not Come ON [03/2020 - ]: Procedure
WARNING: This page is about a different car, the 2024 Toyota Camry, 2023 Toyota Camry, 2022 Toyota Camry, 2021 Toyota Camry, and 2020 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR
- Check that there is no looseness at the locking and connecting parts of the 4WD ECU assembly connector.
OK
No looseness at the locking and connecting parts
- Disconnect the K145 4WD ECU assembly connector.
- Check the connector case and the terminal for deformation and corrosion.
OK
No deformation or corrosion
- Connect the K145 4WD ECU assembly connector.
Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- Check that there is no looseness at the locking and connecting parts of the 4WD ECU assembly connector.
- CHECK 4WD WARNING MESSAGE
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- According to the display on the Techstream, read the Data List.
Chassis > Four Wheel Drive > Active Test
Tester Display Measurement Item Control Range Diagnostic Note 4WD Warning Light AWD warning (multi-information display) Warning ON/OFF Observe combination meter assembly Chassis > Four Wheel Drive > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note 4WD Warning Light AWD warning (multi-information display) OFF or ON OFF: Warning off
ON: Warning on- Chassis > Four Wheel Drive > Active Test
Active Test Display 4WD Warning Light Data List Display 4WD Warning Light Result
Result Proceed to Data List display does not switch ON/OFF A Data List display switches ON/OFF B
Result:
A
REPLACE 4WD ECU ASSEMBLY. Refer to REMOVAL [03/2020 - 10/2020] , or refer to REMOVAL [10/2020 - ]
Result:
B
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2017 - ]