Caution / Notice / Hint
WARNING: This page is about a different car, the 2024 Toyota Camry, 2023 Toyota Camry, 2022 Toyota Camry, 2021 Toyota Camry, and 2020 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [03/2017 - 10/2020] |
| Pre-collision system | |||
| Intelligent clearance sonar system*4 | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [03/2017 - ] | |
| Panoramic view monitor system | Refer to INITIALIZATION [06/2017 - 10/2020] | ||
| Replacement of ECM | Vehicle Identification Number (VIN) registration | MIL comes on | Refer to REGISTRATION [03/2017 - ] |
| ECU communication ID registration (Immobiliser system) | Engine start function | Refer to REGISTRATION [09/2019 - 08/2022]
*1 Refer to REGISTRATION [09/2019 - ] *2 |
|
| Replacement of ECM (If possible, read the transaxle compensation code from the previous ECM) |
|
|
Refer to INITIALIZATION [03/2020 - ]
for UB80F Initialization Refer to REGISTRATION [03/2020 - ] for UB80F Registration |
| Replacement of ECM (If impossible, read the transaxle compensation code from the previous ECM) |
|
||
| Replacement of ECM*1 | Code registration (Smart key System (for Start Function)) |
|
Refer to REGISTRATION [09/2019 - 08/2022] |
| Replacement of ECM*2 | Code registration (Immobiliser system (w/o Smart Key System)) |
|
Refer to REGISTRATION [09/2019 - ] |
- *1: w/ Smart Key System
- *2: w/o Smart Key System
- *3: When the ECM is replaced with a new one, reset memory is unnecessary.
- *4: When performing learning using the Techstream.
Refer to CALIBRATION [06/2017 - 10/2020]