Installation [03/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Toyota Camry, 2023 Toyota Camry, 2022 Toyota Camry, 2021 Toyota Camry, and 2020 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
Connect the transmission control cable assembly to the vehicle body with the 2 nuts.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

Connect the transmission control cable assembly to the transmission control shaft lever as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Correct
*b	Incorrect

NOTE:

Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.

INSTALL NO. 1 CONSOLE BOX DUCT (for Dual Type)
1. Install the No. 1 console box duct.
INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
Refer to INSTALLATION [03/2020 - ]
INSTALL FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
1. Install the front lower No. 1 floor heat insulator to the vehicle body with the 2 nuts.
  Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf)
INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
Refer to INSTALLATION [03/2020 - ]
INSTALL BATTERY CLAMP SUB-ASSEMBLY
Refer to PROCEDURE - Step 45 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 45 [10/2020 - ]
INSTALL ECM
Refer to INSTALLATION [03/2017 - ]
INSTALL BATTERY
Refer to INSTALLATION [08/2018 - ]
INSPECT SHIFT LEVER POSITION
See step 2
ADJUST SHIFT LEVER POSITION
Refer to ADJUSTMENT [03/2020 - ]