Replacement [03/2020 - 10/2020]: Procedure

WARNING: This page is about a different car, the 2024 Toyota Camry, 2023 Toyota Camry, 2022 Toyota Camry, 2021 Toyota Camry, and 2020 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Refer to REMOVAL [03/2020 - 10/2020]

REMOVE FRONT DRIVE SHAFT OIL SEAL LH

Using SST, remove the front drive shaft oil seal LH from the automatic transaxle case sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

SST: 09308-00010

NOTE:

Be careful not to damage the automatic transaxle case sub-assembly.

INSTALL FRONT DRIVE SHAFT OIL SEAL LH

Using SST and a hammer, install a new front drive shaft oil seal LH to the automatic transaxle case sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Depth

SST: 09649-17010
SST: 09950-70010
1. 09951-07100

Standard Depth

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTE:

Make sure that the outer lip of the front drive shaft oil seal LH is not pinched by SST.

*a	Correct
*b	Incorrect
*c	Outer Lip

Do not allow foreign matter to attach to the inner lip and outer lip of the front drive shaft oil seal LH.
Do not install the front drive shaft oil seal LH at an angle.
Do not remove the grease from the inner lip and outer lip of the front drive shaft oil seal LH.

INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Refer to INSTALLATION [03/2020 - ]