LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft / Propeller Shaft - Service Information (Except Hybrid) >> FRONT DRIVE SHAFT ASSEMBLY (for A25A-FKS) >> Inspection [03/2017 - 06/2017] >> Procedure

Inspection [03/2017 - 06/2017]: Procedure

  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY223263Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no excessive play in the radial direction of the inboard joint.
    4. Check the boots for damage.
    5. Check whether the drive shaft dimension (A) and (B) are within specification.
      NOTE:

      Keep the drive shaft assembly level during inspection.

      Dimension (A)

      For LH Side 591.2 mm (1.94 ft.)
      For RH Side 915.0 mm (3.00 ft.)
      GTY752753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A For LH Side
      *B For RH Side

      Dimension (B)

      For LH Side 88.2 mm (3.47 in.)
      For RH Side 96.8 to 97.8 mm (3.82 to 3.85 in.)
scientia non olet · About LEMON Manuals