Caution / Notice / Hint
NOTE:
- After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Refer to CALIBRATION [10/2020 - 08/2021] , or refer to CALIBRATION [08/2021 - ]
- After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Refer to TEST MODE PROCEDURE [10/2020 - 08/2021] , or refer to TEST MODE PROCEDURE [08/2021 - ]
- After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Refer to TEST MODE PROCEDURE [10/2020 - 08/2021] , or refer to TEST MODE PROCEDURE [08/2021 - ]
- DTC precaution
Refer to PRECAUTION [10/2020 - ]
PROCEDURE TO CLEAR WARNING LIGHTS (WHEN NOT CLEARING DTCS)Procedure - Repair or replacement.
- Turn the ignition switch to ON.
- Drive the vehicle at 11 km/h (7 mph) or more for 1 second or more to clear the warning lights.