Installation [06/2017 - ]: Procedure

1. Apply a light coat of lithium soap base glycol grease to a new O-ring.
2. Install the O-ring to the rear disc brake cylinder assembly.
   NOTE:

   Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly.

3. Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.

   Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) 

1. Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.

Refer to PROCEDURE - Step 1