- REMOVE SPARE WHEEL COVER ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE REAR SEAT ASSEMBLY
Refer to REMOVAL [10/2020 - ]
- REMOVE CENTER STOP LIGHT SET
Refer to REMOVAL [03/2017 - ]
- REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD
- Remove the luggage compartment trim inner pad.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH
Refer to PROCEDURE - Step 12
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
- REMOVE INNER ROOF SIDE GARNISH LH
Refer to PROCEDURE - Step 15 [10/2020 - 08/2021]
, or refer to PROCEDURE - Step 15 [08/2021 - ]
- REMOVE INNER ROOF SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
- REMOVE REAR SEAT SHOULDER BELT HOLE COVER
Refer to PROCEDURE - Step 15
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
- Remove the 2 clips.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 3 clips and 5 guides.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
- REMOVE ROOM PARTITION BOARD LH
- Remove the clip.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 2 claws.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 4 clips to remove the room partition board LH.
- REMOVE ROOM PARTITION BOARD RH
- Remove the 2 clips.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 5 clips to remove the room partition board RH.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE REAR SEATBACK LOCK ASSEMBLY LH
- Release the stopper and disengage the guige as shown in the illustration.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
| *a |
Stopper |
 |
Release |
 |
Remove in this Direction (1) |
 |
Remove in this Direction (2) |
- Remove the 2 nuts and rear seatback lock assembly LH.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE REAR SEATBACK LOCK ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.