LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Body & Frame >> Seats >> Seats - Service Information (2 Of 2) (Except Hybrid) >> Rear Seat Reclining Control Cable >> Installation [03/2017 - ] >> Procedure

Installation [03/2017 - ]: Procedure

  1. INSTALL REAR SEATBACK LOCK ASSEMBLY LH 
    1. Install the rear seatback lock assembly LH with the 2 nuts.

      Torque: 18 N.m (184 kgf/cm, 13 ft.lbf) 

    2. Engage the guide to connect the rear seatback lock assembly LH as shown in the illustration.
      GTY744558Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction (1)
      Install in this Direction (2)
  2. INSTALL REAR SEATBACK LOCK ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  3. INSTALL ROOM PARTITION BOARD RH 
    1. Engage the 5 clips.
    2. Install the room partition board RH with the 2 clips.
  4. INSTALL ROOM PARTITION BOARD LH 
    1. Engage the 4 clips and 2 claws.
    2. Install the room partition board LH with the clip.
  5. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
    2. Engage the 3 clips and 5 guides.
    3. Install the package tray trim panel assembly with the 2 clips.
  6. INSTALL REAR SEAT SHOULDER BELT HOLE COVER 

    Refer to PROCEDURE - Step 6 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 6 [06/2017 - 09/2019] , or refer to PROCEDURE - Step 6 [09/2019 - ]

  7. INSTALL INNER ROOF SIDE GARNISH LH 

    Refer to PROCEDURE - Step 20 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 21 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 21 [08/2018 - 09/2019] , or refer to PROCEDURE - Step 18 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 18 [03/2020 - 08/2021] , or refer to PROCEDURE - Step 18 [08/2021 - ]

  8. INSTALL INNER ROOF SIDE GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  9. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH 

    Refer to PROCEDURE - Step 8 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 8 [06/2017 - 09/2019] , or refer to PROCEDURE - Step 8 [09/2019 - ]

  10. CONNECT REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  11. INSTALL LUGGAGE COMPARTMENT TRIM INNER PAD 
    1. Install the luggage compartment trim inner pad.
  12. INSTALL CENTER STOP LIGHT SET 

    Refer to INSTALLATION [03/2017 - ]

  13. INSTALL REAR SEAT ASSEMBLY 

    Refer to INSTALLATION [03/2017 - 06/2017] , or refer to INSTALLATION [06/2017 - 09/2019] , or refer to INSTALLATION [09/2019 - ] 

  14. INSTALL SPARE WHEEL COVER ASSEMBLY 

    Refer to PROCEDURE - Step 10 [03/2017 - 09/2019] , or refer to PROCEDURE - Step 10 [09/2019 - ]

scientia non olet · About LEMON Manuals