LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) (Except Hybrid) >> Fuel Lid Opener Motor Assembly >> Inspection [03/2017 - ] >> Procedure

Inspection [03/2017 - ]: Procedure

  1. INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY 
    1. Check the operation of the fuel lid lock with motor assembly (motor operation).
      1. Apply battery voltage to the fuel lid lock with motor assembly connector, and check the operation of the fuel lid lock with motor assembly.
        GTY760544Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Fuel Lid Lock with Motor Assembly)        		 *b Shaft Stroke
        *c Lever - -

        OK

        Battery Connection Specified Condition
        Battery positive (+) → Terminal 1
        Battery negative (-) → Terminal 2        		 Shaft not extended

        If the result is not as specified, replace the fuel lid lock with motor assembly.

    2. Measure the shaft stroke.

      Standard

      Area Condition Specified Condition
      Shaft stroke Lever pulled 16.05 mm
      (0.632 in.)

      If the result is not as specified, replace the fuel lid lock with motor assembly.

scientia non olet · About LEMON Manuals