LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock System - Service Information (Except Hybrid) >> Front Door Lock >> Removal [06/2017 - 09/2019] >> Procedure

Removal [06/2017 - 09/2019]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [06/2017 - 09/2019]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    For A25A-FKS:

    Refer to PROCEDURE - Step 2 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 2 [08/2018 - 10/2020]

    For 2GR-FKS:

    Refer to PROCEDURE - Step 2

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH 

    Refer to PROCEDURE - Step 3 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 3 [08/2018 - 09/2019]

  4. REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 4 [08/2018 - 09/2019]

  5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side) 

    Refer to PROCEDURE - Step 5 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 5 [08/2018 - 09/2019]

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side) 

    Refer to PROCEDURE - Step 6 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 6 [08/2018 - 09/2019]

  7. REMOVE FRONT ARMREST ASSEMBLY 

    Refer to PROCEDURE - Step 7 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 7 [08/2018 - 09/2019]

  8. REMOVE COURTESY LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 1

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 9 [08/2018 - 09/2019]

  10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL 

    Refer to PROCEDURE - Step 10 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 10 [08/2018 - 09/2019]

  11. REMOVE FRONT DOOR SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 17 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 17 [08/2018 - 09/2019]

  12. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 19 [08/2018 - 09/2019]

  13. REMOVE FRONT DOOR PANEL PROTECTOR 

    Refer to PROCEDURE - Step 21 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 21 [08/2018 - 09/2019]

  14. REMOVE FRONT DOOR GLASS RUN 

    Refer to PROCEDURE - Step 22 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 22 [08/2018 - 09/2019]

  15. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 23 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 23 [08/2018 - 09/2019]

  16. REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side) 

    Refer to PROCEDURE - Step 24 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 24 [08/2018 - 09/2019]

  17. REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side) 

    Refer to PROCEDURE - Step 25 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 25 [08/2018 - 09/2019]

  18. REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY 
    1. Disconnect the connector.
      GTY773520Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Front Door Lock Open Rod
      Remove in this Direction
    2. Using a T30 "TORX" socket wrench, remove the 3 screws.
    3. Slide the front door lock with motor assembly downward to disconnect the front door lock open rod and remove the front door lock with motor assembly and cables as a unit.
    4. When reusing the front door lock with motor assembly:
      1. Remove the door lock wiring harness seal from the front door lock with motor assembly.
        GTY746627Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY 
    1. Using a screwdriver, disengage the 2 claws as shown in the illustration.
      GTY746630Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 claws to remove the front door lock cover sub-assembly as shown in the illustration.
      GTY745222Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  20. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY 
    1. Remove the front door lock remote control cable assembly as shown in the illustration.
      GTY746733Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  21. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY 
    1. Remove the front door inside locking cable assembly as shown in the illustration.
      GTY748877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals