Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat assembly removal/installation are shown below.
*: When performing learning using the Techstream.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [03/2017 - 10/2020] |
| Pre-collision system | |||
| Intelligent clearance sonar system* | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [03/2017 - ] | |
| Panoramic view monitor system | Refer to INITIALIZATION [06/2017 - 10/2020] | ||
|
Zero point calibration (Occupant classification system) |
|
Refer to INITIALIZATION [06/2017 - ] |
*: When performing learning using the Techstream.
WARNING:
- Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [06/2017 - 09/2019] , or refer to PRECAUTION [09/2019 - 03/2020] , or refer to PRECAUTION [03/2020 - 10/2020]
- Wear protective gloves. Sharp areas on the parts may injure your hands.
NOTE:
If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.