LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Service Information (Except Hybrid) >> Navigation Ecu >> Installation [10/2020 - ] >> Procedure

Installation [10/2020 - ]: Procedure

  1. PRECAUTION 
    NOTE:
    • When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
      • A communication malfunction DTC may be stored.
      • The radio and display receiver assembly or navigation ECU may not operate normally.
    • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.
  2. INSTALL NAVIGATION ECU 
  3. INSTALL DCM (TELEMATICS TRANSCEIVER) (w/ Manual (SOS) Switch) 
  4. INSTALL NO. 1 TELEPHONE BRACKET 
    1. w/o Manual (SOS) Switch:
      1. Install the No. 1 telephone bracket with the 2 screws.
    2. w/ Manual (SOS) Switch:
      1. Install the No. 1 telephone bracket with the 3 screws.
  5. INSTALL NO. 2 TELEPHONE BRACKET 
    1. w/o Manual (SOS) Switch:
      1. Install the No. 2 telephone bracket with the 2 screws.
    2. w/ Manual (SOS) Switch:
      1. Install the No. 2 telephone bracket with the 3 screws.
  6. INSTALL ANTENNA CORD SUB-ASSEMBLY 
    1. w/o Manual (SOS) Switch:
      1. Engage the clamp to install the antenna cord sub-assembly.
      2. Connect the connector.
    2. w/ Manual (SOS) Switch:
      1. Engage the clamp to install the antenna cord sub-assembly.
      2. Connect the 4 connectors.
  7. INSTALL NAVIGATION ECU WITH BRACKET 
    1. Connect each connector.
    2. Engage the clamp.
    3. Engage the 3 guides.
    4. Install the navigation ECU with bracket with the 3 bolts.
    5. Connect each connector.
  8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6

  9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 

    For UB80E:

    Refer to PROCEDURE - Step 1

    For UA80E:

    Refer to PROCEDURE - Step 1

    For UB80F:

    Refer to PROCEDURE - Step 1

  10. INSTALL SHIFT LOCK RELEASE BUTTON COVER 

    For UB80E:

    Refer to PROCEDURE - Step 5

    For UA80E:

    Refer to PROCEDURE - Step 5

    For UB80F:

    Refer to PROCEDURE - Step 5

  11. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 9

  12. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH 

    Refer to PROCEDURE - Step 10

  13. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 19

  14. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 7 Inch Display) 

    Refer to PROCEDURE - Step 20

  15. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 9 Inch Display) 

    Refer to PROCEDURE - Step 21

  16. INSTALL AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to INSTALLATION [10/2020 - ]

scientia non olet · About LEMON Manuals