LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> HEADUP Display System - Diagnostics - Introduction (Except Hybrid) >> HEADUP Display System >> Data List / Active Test [06/2017 - 10/2020] >> Data List / Active Test [06/2017 - 10/2020]

Data List / Active Test [06/2017 - 10/2020]

  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Head Up Display / Data List.
    5. Read the Data List according to the display on the Techstream.

      Body Electrical > Head Up Display > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Total Distance Traveled Total driving distance Min.: 0, Max.: 16777215 Current total driving distance -
      Total Distance Traveled - Unit Total driving distance unit km or mile Current total driving distance unit -
      +B Voltage Battery voltage Min.: 0 V, Max.: 25.5 V or Unset 11 to 14 V -
      Illumination Rate from Illuminance Sensor Light control sensor input value Min.: 0 lx, Max.: 65535 lx or Unset Value according to the brightness is output 0 is displayed when there is no light
      Vehicle Speed Meter Vehicle speed input value (Brake ECU) Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) or Unset Almost the same as actual vehicle speed -
      Engine RPM Engine speed Min.: 0 rpm, Max.: 12701 rpm or Unset Almost the same as actual tachometer -
      Brightness Up Switch Brightness up switch OFF or ON OFF: Switch released
      ON: Switch pushed      		 This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display.
      Brightness Down Switch Brightness down switch OFF or ON OFF: Switch released
      ON: Switch pushed      		 This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display.
      Projection Position Up Switch Projection position up switch OFF or ON OFF: Switch released
      ON: Switch pushed      		 This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display.
      Projection Position Down Switch Projection position down switch OFF or ON OFF: Switch released
      ON: Switch pushed      		 This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display.
      Display Change Switch Headup display switch (CAN communication line) OFF or ON OFF: Switch released
      ON: Switch pushed      		 -
      Display Angle Display angle of headup display Min.: -12.7 deg, Max.: 12.7 deg or Unset Current display angle of headup display
      • Approximately -12.7 deg: vehicle rear
      • Approximately 12.7 deg: vehicle front
      Ambient Temperature (Celsius) Outside temperature (Celsius) Min.: -40.0°C, Max.: 87.1°C or Unset Almost the same as actual outside temperature -
      Ambient Temperature (Fahrenheit) Outside temperature (Fahrenheit) Min.: -40°F, Max.: 215°F or Unset Almost the same as actual outside temperature -
      Illumination Rate from Light Control Sensor Light control sensor input value Min.: 0 lx, Max.: 65535 lx or Unset Value according to the brightness is output Not applicable to this vehicle
      LDA System Existence of lane departure alert system Without or With Without: w/o Lane Departure Alert System
      With: w/ Lane Departure Alert System      		 -
      PCS System Existence of pre-collision system Without or With Without: w/o Pre-collision System
      With: w/ Pre-collision System      		 -
      ICS System Existence of intelligent clearance sonar system Without or With Without: w/o Intelligent Clearance Sonar System
      With: w/ Intelligent Clearance Sonar System      		 -
      Radar Cruise System Existence of dynamic radar cruise control system Without or With Without: w/o Dynamic Radar Cruise Control System
      With: w/ Dynamic Radar Cruise Control System      		 -
      Intuitive P/A System Existence of intuitive parking assist system Without or With Without: w/o Intuitive Parking Assist System
      With: w/ Intuitive Parking Assist System      		 -
      Road Sign Assist System Existence of road sign assist system Without or With Without: w/o Road Sign Assist System
      With: w/ Road Sign Assist System      		 -
      HV System Indicator Hybrid system indicator value Min.: -101%, Max.: 511% or Unset Current hybrid system indicator value Not applicable to this vehicle
      Navigation System Existence of navigation system Without or With Without: w/o Navigation System
      With: w/ Navigation System      		 -
      Master Caution Display Function Setting of master warning light OFF or ON OFF: Master warning light not displayed
      ON: Master warning light displayed      		 Displays customize setting of Master Warning Light Function
      Speed Limit Display Function Setting of speed limit display OFF or ON OFF: Speed limit display not displayed
      ON: Speed limit display displayed      		 Displays customize setting of Speed Limit Display Function
      Memory Call Link Function Setting of headup display memory call link function OFF or ON OFF: Memory call link function off
      ON: Memory call link function on      		 Displays customize setting of Memory Call Link Function
      Seat Switch Link Function Setting of headup display power seat switch link function OFF or ON OFF: Power seat switch link function off
      ON: Power seat switch link function on      		 Displays customize setting of Power Seat Switch Link Function
      ECO Drive Indicator Zone Display Function Setting of ECO driving indicator zone OFF or ON OFF: Eco driving indicator zone not displayed
      ON: Eco driving indicator zone displayed      		 Displays customize setting of ECO Driving Indicator Zone Display Function
      LVN System Existence of traffic movement notification system Without or With Without: w/o Traffic Movement Notification System
      With: w/ Traffic Movement Notification System      		 -
      Driver Emergency Stop Assist System Existence of driver emergency stop assist Without or With Without: w/o Driver Emergency Stop Assist
      With: w/ Driver Emergency Stop Assist      		 -

      HINT: 

      Depending on the specifications of the vehicle, some items may not be displayed.

  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Head Up Display / Active Test.
    5. Perform the Active Test according the display on the Techstream.

      Body Electrical > Head Up Display > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Color Test Screen (Black) Headup display (Black color) OFF or ON -
      Color Test Screen (White) Headup display (White color) OFF or ON -
      Color Test Screen (Red) Headup display (Red color) OFF or ON -
      Color Test Screen (Green) Headup display (Green color) OFF or ON -
      Color Test Screen (Blue) Headup display (Blue color) OFF or ON -
      Color Test Screen (Color Bars) Headup display (Color bars) OFF or ON -
      Color Test Screen (Adjustment) Headup display (Adjustment screen) OFF or ON -
      Display Brightness Headup display (Display brightness) 0 to 100% -
      Display Position Headup display (Display position) Up (+3), Up (+2), Up (+1), Center, Down (-1), Down (-2) or Down (-3) -

      HINT: 

      Depending on the specifications of the vehicle, some items may not be displayed.

scientia non olet · About LEMON Manuals