DTC C1626: Steering Angle Sensor Failure [06/2017 - 10/2020]: Procedure

1. Replace the steering sensor with a new or known good one.

   Refer to REMOVAL [06/2017 - 10/2020]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Using the Techstream, check for DTCs according to the prompts on the screen.

   HINT: 

   After turning the engine switch from off to on (IG), wait 4 seconds or more before

   Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes 

2. Clear the DTCs according to the screen on the Techstream.

   Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs 

3. Recheck for DTCs.

   Result

   Result	Proceed to
   DTC C1626 is output	A
   DTC C1626 is not output	B

Result: 

A 

REPLACE CLEARANCE WARNING ECU ASSEMBLY. Refer to  REMOVAL [06/2017 - 10/2020] 

Result: 

B 

END (STEERING SENSOR DEFECTIVE)