On-Vehicle Inspection [10/2014 - ]: Procedure
- INSPECT REAR SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
- Visually check for defects on the rear seat outer belt assembly installed on the vehicle.
- The defects to be checked are as follows:
- Cuts on the rear seat outer belt assembly
- Small cracks on the rear seat outer belt assembly
- Significant discoloration on the rear seat outer belt assembly
OK
No defects are found.
HINT:
If any of the defects are found, replace the rear seat outer belt assembly with a new one.
- The defects to be checked are as follows:
- Visually check for defects on the rear seat outer belt assembly installed on the vehicle.
- INSPECT REAR SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
- Visually check for defects on the rear seat outer belt assembly removed from the vehicle.
- The defects to be checked are as follows:
- Cuts on the rear seat outer belt assembly
- Small cracks on the rear seat outer belt assembly
- Significant discoloration on the rear seat outer belt assembly
- Cracks or other damage on the connector
OK
No defects are found.
HINT:
If any of the defects are found, replace the rear seat outer belt assembly with a new one.
- The defects to be checked are as follows:
- Visually check for defects on the rear seat outer belt assembly removed from the vehicle.