LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Avalon XLE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Except Hybrid) >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> On-Vehicle Inspection [10/2014 - ] >> Procedure

On-Vehicle Inspection [10/2014 - ]: Procedure

  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision) 
    1. Perform a diagnostic system check (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
    2. Visually check for defects on the front seat outer belt assembly installed on the vehicle.
      1. The defects to be checked are as follows:
        • Cuts on the front seat outer belt assembly
        • Small cracks on the front seat outer belt assembly
        • Significant discoloration on the front seat outer belt assembly

        OK

        No defects are found.

        HINT: 

        If any of the defects are found, replace the front seat outer belt assembly with a new one.

  2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision) 
    1. Perform a diagnostic system check (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
    2. Visually check for defects on the front seat outer belt assembly removed from the vehicle.
      1. The defects to be checked are as follows:
        • Cuts on the front seat outer belt assembly
        • Small cracks on the front seat outer belt assembly
        • Significant discoloration on the front seat outer belt assembly
        • Cracks or other damage on the connector

        OK

        No defects are found.

        HINT: 

        If any of the defects are found, replace the front seat outer belt assembly with a new one.

scientia non olet · About LEMON Manuals