LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Avalon XLE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Except Hybrid) >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Inspection [10/2014 - 10/2015] >> Procedure

Inspection [10/2014 - 10/2015]: Procedure

  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY 
    1. Check the pre-collision seat belt. (w/ Pre-collision System)
      GTY574608Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.
        STANDARD RESISTANCE

        Tester Connection Condition Specified Condition
        1 - 2 Always Below 1 MΩ
        TEXT IN ILLUSTRATION

        *1 Pre-collision Seat Belt Connector
        *a Component without harness connected
        (Front Seat Outer Belt Assembly)
        1. If the result is not as specified, replace the front seat outer belt assembly.
    2. Before installing the front seat outer belt assembly, check the ELR function.
      GTY479520Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not disassemble the retractor.

      1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
        TEXT IN ILLUSTRATION

        *1 Retractor
        *a Unlocked
        *b Locked
        *c 45°

        If the result is not as specified, replace the outer belt assembly.

scientia non olet · About LEMON Manuals