LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Avalon XLE >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Pre-Collision System Warning Buzzer (Service Information) (Except Hybrid) >> Pre-Collision System Warning Buzzer >> Installation [10/2015 - ] >> Procedure

Installation [10/2015 - ]: Procedure

  1. INSTALL SKID CONTROL BUZZER ASSEMBLY 
    NOTE:

    If the skid control buzzer assembly has been struck or dropped, replace it with a new one.

    1. Connect the connector.
    2. Engage the clamp to install the skid control buzzer assembly.

      HINT: 

      Make sure to install the skid control buzzer assembly in the correct direction.

  2. INSTALL LOWER NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 35

  3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 36

  4. INSTALL INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 37

  5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 34

  6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 35

  7. INSTALL FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 36

  8. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 8

scientia non olet · About LEMON Manuals