DTC C1694: Steering Angle Initialization Incomplete [10/2014 - ]: Procedure

1. Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
   1. Steering angle setting (Refer to CALIBRATION [10/2014 - ] ).

Result: 

NEXT 

See step  2

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Recheck for DTCs and check that no DTCs are output (Refer to DTC CHECK / CLEAR [10/2014 - ] ).

   HINT: 

   • If DTC C1694 is output, perform the steering angle setting again.
   • If DTC C1694 is still output after performing the steering angle setting 3 times, replace the rear television camera assembly.

   Result

   Result	Proceed to
   DTC C1694 is output	A
   DTC C1694 is not output	B

Result: 

A 

REPLACE REAR TELEVISION CAMERA ASSEMBLY 

(Refer to REMOVAL [10/2014 - ] )

Result: 

B 

END