Multi-terrain Select Indicator Light does not Come ON [08/2019 - ]: Procedure

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Refer to DIAGNOSIS SYSTEM [08/2019 - 08/2021] , or refer to DIAGNOSIS SYSTEM [08/2021 - 08/2022] , or refer to DIAGNOSIS SYSTEM [08/2022 - ] ).

   OK

   CAN Bus Check indicates no malfunctions in CAN communication.

Result: 

NG 

GO TO CAN COMMUNICATION SYSTEM (HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS). Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

OK 

See step  2

1. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2019 - ] ).
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - ] 

Result: 

A 

See step  3

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Enter the following menus: Body Electrical / D-SEAT SW / Data List.
   D-SEAT SW
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Off-road Guidance Switch	Multi-terrain select switch/ ON or OFF	ON: Multi-terrain select switch on OFF: Multi-terrain select off	-

   OK

   The Techstream displays ON or OFF according to multi-terrain select switch operation.

Result: 

OK 

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] 

Result: 

NG 

See step  4

Refer to PROCEDURE - Step 10

Result: 

OK 

REPLACE DRIVE MONITOR SWITCH. Refer to  REMOVAL [08/2015 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR