DTC B150A: Lost Communication with HMI-LAN [08/2019 - ]: Procedure

1. Choose the model to be inspected.

   Result

   Result	Proceed to
   w/o Navigation System	A
   w/ Navigation System	B

Result: 

B 

See step  4

Result: 

A 

See step  2

1. Check if audio and visual system DTCs are output.

   Refer to DTC CHECK / CLEAR [08/2019 - ]

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO AUDIO AND VISUAL SYSTEM. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - 08/2022]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2022 - ] 

Result: 

A 

See step  3

1. Replace the combination meter assembly with a new one.

   Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ]

2. Turn the ignition switch to ON and wait 30 seconds.
   NOTE:

   A maximum of 30 seconds is required to send/receive the registration information between the combination meter assembly and radio and display receiver assembly.

3. Operate the steering pad switch assembly and check that the audio tab illuminates.
4. Check if meter / gauge system DTCs are output.

   Refer to DTC CHECK / CLEAR [08/2015 - ]

   Result

   Result	Proceed to
   The audio tab illuminates and DTC B150A is not output	A
   The audio tab does not illuminate and DTC B150A is output	B

Result: 

A 

END (COMBINATION METER ASSEMBLY WAS DEFECTIVE) 

Result: 

B 

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [08/2019 - ] 

1. Check if navigation system DTCs are output.

   Refer to DTC CHECK / CLEAR [08/2019 - ]

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO NAVIGATION SYSTEM. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - 08/2022]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2022 - ] 

Result: 

A 

See step  5

1. Replace the combination meter assembly with a new one.

   Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ]

2. Turn the ignition switch to ON and wait 30 seconds.
   NOTE:

   A maximum of 30 seconds is required to send/receive the registration information between the combination meter assembly and navigation receiver assembly.

3. Operate the steering pad switch assembly and check that the audio tab illuminates.
4. Check if meter / gauge system DTCs are output.

   Refer to DTC CHECK / CLEAR [08/2015 - ]

   Result

   Result	Proceed to
   The audio tab illuminates and DTC B150A is not output	A
   The audio tab does not illuminate and DTC B150A is output	B

Result: 

A 

END (COMBINATION METER ASSEMBLY WAS DEFECTIVE) 

Result: 

B 

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [08/2019 - ]