LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> RAV4 XLE, FWD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft / Propeller Shaft (Service Information) (Except Hybrid) >> Rear Drive Shaft Assembly >> Inspection [12/2012 - ] >> Procedure

Inspection [12/2012 - ]: Procedure

  1. INSPECT REAR DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY313524Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no severe play in the radial direction of the inboard joint.
    4. Check the 2 joint boots for damage.
    5. Check that the 2 joint boots are not stretched or contracted when the rear drive shaft assembly is at the standard length.
      GTY367015Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Length (A)

      733.2 mm (2.40 ft.)

      NOTE:

      Keep the drive shaft assembly level during inspection.

      If the boots are stretched or contracted, correct them.

scientia non olet · About LEMON Manuals