Installation [10/2015 - 08/2016]: Procedure

1. Install the brake actuator with bracket with the 3 nuts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

   NOTE:

   • Tighten the 3 nuts uniformly in alphabetical order.
   • Be careful not to damage the brake tubes.
2. Connect the 3 clamps to the brake actuator bracket assembly.
3. Temporarily install each brake line to the correct positions of the brake actuator assembly with bracket as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	To Front Wheel Cylinder RH
   *b	To Front Wheel Cylinder LH
   *c	To Rear Wheel Cylinder RH
   *d	To Rear Wheel Cylinder LH
   *e	From Front Master Cylinder
   *f	From Rear Master Cylinder

4. Using a union nut wrench, tighten each 6 brake lines.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Torque Wrench Fulcrum Length

   Specified tightening torque 

   Torque: 15.2 N*m (155 kgf*cm, 11 ft.*lbf) 

   HINT: 

   • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

     Refer to PRECAUTION [12/2012 - ]

   • When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
5. Connect the clamp to the brake actuator bracket assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

6. Connect the wire harness connector to the brake actuator assembly, and then push up the lock lever to apply the lock.
   NOTE:

   • Before connecting the wire harness connector, make sure that the surfaces of the wire harness connector are free of foreign matter.
   • After connecting the wire harness connector, make sure that the lock lever is securely locked.

Refer to INSTALLATION [12/2012 - ]

Refer to BLEEDING [12/2012 - ]

Refer to ON-VEHICLE INSPECTION [10/2015 - ]