LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seats (Service Information) (Except Hybrid) (2 Of 2) >> REAR SEAT ASSEMBLY (for RH Side) >> Removal [08/2016 - ] >> Procedure

Removal [08/2016 - ]: Procedure

  1. REMOVE REAR SEAT FRONT BRACKET COVER RH 
    1. Using a screwdriver, detach the 4 claws.
      GTY370906Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Tape the screwdriver tip before use.

    2. Detach the 2 guides and remove the rear seat front bracket cover RH in the direction shown by the arrow in the illustration.
  2. REMOVE REAR SEAT NO. 2 LEG SIDE COVER 
    1. Using a screwdriver, detach the 4 claws to remove the rear seat No. 2 leg side cover.

      HINT: 

      Tape the screwdriver tip before use.

      GTY370905Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR SEAT ASSEMBLY RH 
    1. Remove the 2 bolts on the front side of the seat.
      GTY370171Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. GTY380506Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Rubber Band

      Disconnect the 2 connectors.

    3. Pass the rear seat center lap type belt assembly RH through the rubber band of the separate type rear seat cushion cover.
    4. Remove the 3 bolts on the rear side of the seat.
    5. Fully tilt the seatback forward. Then remove the seat.
      NOTE:

      Be careful not to damage the vehicle body.

  4. REMOVE SEAT LEG BRACKET 
    GTY370169Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Detach the clamp and remove the 4 bolts.
    2. Detach the guide to remove the seat leg bracket.
scientia non olet · About LEMON Manuals