Reassembly [10/2015 - ]: Procedure

INSTALL HEADLIGHT GASKET
1. Install a new headlight gasket to the ECU base.

INSTALL NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH

Install the No. 1 headlight ECU sub-assembly LH to the ECU base with the 2 screws.
Connect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Matchmark
*b	Unlock Position Mark
*c	Lock Position Mark

Align the matchmark of the ECU base to the unlock position mark, and then rotate the ECU base clockwise until the lock position mark to install the ECU base.

INSTALL FRONT SIDE MARKER LIGHT BULB

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the front side marker light bulb to the front side marker light socket.

INSTALL FRONT SIDE MARKER LIGHT SOCKET

Align the matchmark of the front side marker light socket to the unlock position mark, and then rotate the front side marker light socket counterclockwise until the lock position mark to install the front side marker light socket.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Matchmark
*b	Unlock Position Mark
*c	Lock Position Mark

INSTALL FRONT TURN SIGNAL LIGHT BULB

Install the front turn signal light bulb to the front turn signal light socket.

INSTALL FRONT TURN SIGNAL LIGHT SOCKET

Align the matchmark of the front turn signal light socket to the unlock position mark, and then rotate the front turn signal light socket clockwise until the lock position mark to install the front turn signal light socket.

*a	Matchmark
*b	Unlock Position Mark
*c	Lock Position Mark