LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> RAV4 LE, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Service Information) (Except Hybrid) >> Side Airbag Sensor >> Installation [12/2012 - ] >> Procedure

Installation [12/2012 - ]: Procedure

  1. INSTALL DOOR SIDE AIRBAG SENSOR LH 
    1. Check that the ignition switch is off.
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Insert the pin (stopper) into the body hole to install the door side airbag sensor LH to the vehicle with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      NOTE:
      • If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
      • When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
      • Make sure that the pin (stopper) is securely inserted into the body hole.
      • Tighten the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.
    4. Connect the connector to the door side airbag sensor LH.
      NOTE:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      1. While holding the outer housing, be sure to engage the connectors until they are locked and check that the outer housing is in its original position (when locking, make sure that a click sound can be heard).
        GTY373944Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *1 Outer Housing - -
    5. Check that there is no looseness in the installation parts of the door side airbag sensor LH.
  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 33

  3. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 

    Refer to PROCEDURE - Step 34

  4. INSTALL FRONT DOOR ASSIST GRIP COVER LH 

    Refer to PROCEDURE - Step 35

  5. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL 

    Refer to PROCEDURE - Step 40

  6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH 

    Refer to PROCEDURE - Step 41

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]

  8. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR [12/2012 - ]

  9. CHECK SRS WARNING LIGHT 

    Refer to DIAGNOSIS SYSTEM [12/2012 - ]

scientia non olet · About LEMON Manuals