LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> RAV4 LE, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) - Service Information - (Except Hybrid) >> Rear Light Assembly >> Removal [10/2015 - ] >> Procedure

Removal [10/2015 - ]: Procedure

  1. REMOVE BACK DOOR CENTER GARNISH 

    Refer to PROCEDURE - Step 1

  2. REMOVE BACK DOOR SIDE GARNISH LH 

    Refer to PROCEDURE - Step 2

  3. REMOVE BACK DOOR SIDE GARNISH RH 

    Refer to PROCEDURE - Step 3

  4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door) 

    Refer to PROCEDURE - Step 5

  6. REMOVE REAR LIGHT ASSEMBLY LH 
    1. Put protective tape around the rear light assembly LH.
      GTY602977Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Disconnect the connector.
      GTY545841Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for Bulb Type Taillight
      *B for LED Type Taillight
    3. Remove the 5 nuts.
    4. Pull the rear light assembly LH towards the rear of the vehicle to remove it.
      GTY593975Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the rear light assembly LH is removed, replace the rear light gasket LH with a new one.

scientia non olet · About LEMON Manuals