Installation [12/2012 - ]: Procedure

1. Temporarily install the rear upper control arm to the rear suspension member and rear axle carrier with the 2 bolts and 2 nuts.

See step  3

1. Using a jack and wooden block, raise the vehicle so that the rear No. 2 suspension arm assembly LH is at the standard vehicle height to apply load to the rear suspension.
2. Tighten the 2 bolts and 2 nuts of the upper control arm.

   Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf) 

   NOTE:

   Since a stopper nut is used, tighten the bolt.

1. Connect the skid control sensor wire to the rear upper control arm with the 2 nuts.

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

Refer to ADJUSTMENT [12/2012 - 08/2017] Refer to ADJUSTMENT [08/2017 - ]