Installation [12/2012 - ]: Procedure

1. Temporarily install the rear trailing arm to the rear suspension arm bracket with the bolt and nut.
2. Install the rear trailing arm to the vehicle with the 3 bolts.

   Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf) 

3. Install the rear trailing arm to the rear axle carrier with the 2 bolts.

   Torque: 200 N*m (2039 kgf*cm, 148 ft.*lbf) 

See step  2

1. Connect the No. 3 parking brake cable to the rear trailing arm with the bolt.

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

See step  3

1. Tighten the nut.

   Torque: 150 N*m (1530 kgf*cm, 111 ft.*lbf) 

See step  4

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

Refer to ADJUSTMENT [12/2012 - 08/2017] Refer to ADJUSTMENT [08/2017 - ]