LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> RAV4 LE, AWD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension (Service Information) (Except Hybrid) >> Rear Shock Absorber >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. REMOVE REAR WHEEL 
  2. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH 
    1. Support the rear No. 2 suspension arm with a jack using a wooden block to avoid damage.
      GTY382279Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not excessively jack up the rear No. 2 suspension arm assembly LH.

      HINT: 

      Support the rear shock absorber at a position where it compresses by approximately 20 to 30 mm (0.788 to 1.181 in.).

    2. Remove the 2 bolts and disconnect the shock absorber with the rear shock absorber bracket.
      GTY308477Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the nut and bolt from the shock absorber upper side.
      GTY384632Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the shock absorber from the vehicle.
  3. REMOVE REAR SHOCK ABSORBER BRACKET LH 
    1. Remove the nut and bolt from the bracket.
      GTY363859Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals