How To Proceed With Troubleshooting [12/2012 - ]: Procedure

VEHICLE BROUGHT TO WORKSHOP
Result:

NEXT

See step 2
INSPECT BATTERY VOLTAGE
Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:

NEXT

See step 3
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
1. Use the Techstream to check if the CAN communication system is functioning normally.
  Refer to DIAGNOSIS SYSTEM [12/2012 - 11/2013] , or refer to DIAGNOSIS SYSTEM [11/2013 - 10/2015] , or refer to DIAGNOSIS SYSTEM [10/2015 - 08/2016] , or refer to DIAGNOSIS SYSTEM [08/2016 - ]
Result:

CAN communication system DTC is output

GO TO CAN COMMUNICATION SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING [12/2012 - 10/2015] , HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ]

Result:

CAN communication system DTC is not output

See step 4
CHECK FOR DTC*
1. Check for DTCs.
  Refer to DTC CHECK / CLEAR [12/2012 - ]
  
  Body Electrical > Combination Meter > Trouble Codes
2. Clear the DTCs.
  Refer to DTC CHECK / CLEAR [12/2012 - ]
  
  Body Electrical > Combination Meter > Clear DTCs
3. Recheck for DTCs.
  Refer to DTC CHECK / CLEAR [12/2012 - ]
  
  Body Electrical > Combination Meter > Trouble Codes
Result:

DTC is output

GO TO DIAGNOSTIC TROUBLE CODE CHART: DIAGNOSTIC TROUBLE CODE CHART [12/2012 - 10/2015] , DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ]

Result:

DTC is not output

See step 5
PROBLEM SYMPTOMS TABLE
1. Refer to Problem Symptoms Table.
  Refer to PROBLEM SYMPTOMS TABLE [12/2012 - 10/2015] , or refer to PROBLEM SYMPTOMS TABLE [10/2015 - 08/2016] , or refer to PROBLEM SYMPTOMS TABLE [08/2016 - 08/2017] , or refer to PROBLEM SYMPTOMS TABLE [08/2017 - ]
Result:

Fault is listed in problem symptoms table

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

Result:

Fault is not listed in problem symptoms table

See step 6
OVERALL ANALYSIS AND TROUBLESHOOTING*
1. Terminals of ECU
  Refer to TERMINALS OF ECU [12/2012 - 10/2015] , or refer to TERMINALS OF ECU [10/2015 - 08/2016] , or refer to TERMINALS OF ECU [08/2016 - ]
2. Data List / Active Test
  Refer to DATA LIST / ACTIVE TEST [12/2012 - 10/2015] , or refer to DATA LIST / ACTIVE TEST [10/2015 - 08/2016] , or refer to DATA LIST / ACTIVE TEST [08/2016 - ]
3. Operation Check
  Refer to OPERATION CHECK [12/2012 - 10/2015] , or refer to OPERATION CHECK [10/2015 - 08/2016] , or refer to OPERATION CHECK [08/2016 - ]
Result:

NEXT

See step 7
REPAIR OR REPLACE
Result:

NEXT

See step 8
CONFIRMATION TEST
Result:

NEXT

END