LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> RAV4 LE, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) (Service Information) (Except Hybrid) >> Brake Master Cylinder >> Disassembly [12/2012 - ] >> Procedure

Disassembly [12/2012 - ]: Procedure

  1. REMOVE BRAKE MASTER CYLINDER RING PIN 
    1. Mount the brake master cylinder sub-assembly in a vise.
      NOTE:

      Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

    2. Using a pin punch and hammer, remove the pin from the brake master cylinder reservoir.
  2. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY 
    1. Remove the brake master cylinder reservoir from the brake master cylinder sub-assembly.
  3. REMOVE MASTER CYLINDER RESERVOIR GROMMET 
    GTY368700Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder sub-assembly.
  4. REMOVE BRAKE FLUID INFORMATION LABEL 
  5. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
    1. Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.
  6. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER 
    1. Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly.
scientia non olet · About LEMON Manuals