Installation [12/2012 - ]: Procedure

INSTALL TELLTALE LIGHT ASSEMBLY
1. Connect the connector.
2. Attach the claw and 2 clips to install the telltale light assembly.
INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 19 [12/2012 - 10/2015] , or refer to PROCEDURE - Step 21 [10/2015 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2012 - 10/2015] , or refer to INITIALIZATION [10/2015 - 08/2016] , or refer to INITIALIZATION [08/2016 - ]