DTC P3147-239: Transmission Malfunction; DTC P3147-241: Transmission Malfunction [08/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   SFI system DTCs are not output.	A
   SFI system DTCs are output.	B

5. Turn the power switch off.

B → Refer to   9 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   DTCs other than P3147-239 or P3147-241 are not output.	A
   DTC P3147-240 or P3147-242 is also output.	B
   DTC P0A1D is also output.	C

5. Turn the power switch off.

B → Refer to   10 

C → Refer to   11 

A: Go to next step 

1. Turn the power switch off.
2. Push the P position switch and lift up the vehicle.
3. Turn the crankshaft pulley using hand tools to check if the crankshaft can rotate smoothly.
   WARNING:

   Do not turn the power switch on (READY) while performing this inspection. Be sure to turn the power switch off before performing this inspection, to prevent the engine from starting.

   NOTE:

   Engine compression causes resistance when turning the crankshaft pulley. Check if the crankshaft rotates smoothly (or if it is locked) by manually applying sufficient torque to turn the crankshaft pulley. The torque required to turn the crankshaft pulley should be the same as for a known good vehicle of the same type.

   Result

   Result	Proceed to
   The crankshaft rotates.	A
   The crankshaft does not rotate.	B

B → Refer to   8 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Read and record the DTCs and freeze frame data.
5. Clear DTCs and freeze frame data.
6. Turn the power switch off.

NEXT: Go to next step 

NG → Refer to   10 

OK: Go to next step 

1. Depress the brake pedal, move the shift lever to D, and release the brake pedal.

   OK

   The wheels turn (the vehicle creeps forward).

   HINT: 

   If the wheels do not turn and the reading on the Techstream shows DTC P3147-239, replace the hybrid vehicle transaxle assembly.

NG → Refer to   10 

OK: Go to next step 

NG → Refer to   13 

OK → Refer to   12 

1. Turn the power switch on (IG) and move the shift lever to N.
2. Lift up the vehicle.
3. Turn the crankshaft pulley using hand tools to check if the crankshaft can rotate smoothly.
   WARNING:

   Do not turn the power switch on (READY) while performing this inspection. Be sure to turn the power switch on (IG) before performing this inspection, to prevent the engine from starting.

   NOTE:

   Engine compression causes resistance when turning the crankshaft pulley. Check if the crankshaft rotates smoothly (or if it is locked) by manually applying sufficient torque to turn the crankshaft pulley. The torque required to turn the crankshaft pulley should be the same as for a known good vehicle of the same type.

   OK

   The crankshaft rotates.

NG → REPAIR OR REPLACE ENGINE 

OK → Refer to   10