DTC P3000-603: HV Battery Malfunction [08/2015 - ]: Procedure
- CHECK DTC OUTPUT (HYBRID CONTROL)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Check if DTCs are output.
Result
Result Proceed to P3000-603 only is output. A DTCs other than P3000-603 are also output. B - Turn the power switch off.
B → Refer to 3
A: Go to next step
- REPLACE POWER MANAGEMENT CONTROL ECU
Refer to COMPONENTS [08/2015 - ]
NEXT → Refer to 4
- GO TO DTC CHART (HYBRID CONTROL SYSTEM). Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - ]
- REPLACE HV BATTERY. Refer to COMPONENTS [08/2015 - ]