Pattern Select Switch Power Mode Circuit [08/2015 - ]: Procedure

B → Refer to   10 

A: Go to next step 

B → GO TO DTC CHART 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Body Electrical / Combination Meter / Active Test / Indicat. Lamp ECT PWR.
4. Perform the "Indicat. Lamp ECT PWR" Active Test.

   OK

   The POWER mode indicator lamp comes on or blinks.

   Result

   Result	Proceed to
   OK	A
   NG (w/o Multi-information Display)	B
   NG (w/ Multi-information Display)	C

5. Turn the power switch off.

B → Refer to   11 

C → Refer to   13 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Data List / Pattern Switch (PWR/M).
4. Read the value displayed on the Techstream.

   Tester Display	Measurement Item/Range	Normal Condition
   Pattern Switch (PWR/M)	PWR mode transition availability/ ON or OFF	In PWR mode: ON

   Result

   Result	Proceed to
   The Techstream display changes according to the PWR switch operation.	A
   The Techstream display does not changes according to the PWR switch operation.	B

B → Refer to   5 

A → Refer to   9 

1. Remove the combination switch assembly.
2. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   L155-8 (PWR) - L155-3 (E)	PWR switch being pushed and held	Below 1 Ω
   	PWR switch not pushed	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Combination Switch Assembly)

3. Install the combination switch assembly.

NG → Refer to   8 

OK: Go to next step 

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Disconnect connector A57 from the ECM.
2. Disconnect connector L155 from the combination switch assembly.
3. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A57-46 (PWMS) - L155-8 (PWR)	Always	Below 1 Ω
   A57-46 (PWMS) or L155-8 (PWR) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to ECM)
   *b	Front view of wire harness connector (to Combination Switch Assembly)

4. Connect the combination switch assembly connector.
5. Connect the ECM connector.

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → Refer to   12