How To Proceed With Troubleshooting [08/2015 - ]

HINT: 

*: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. CUSTOMER PROBLEM ANALYSIS 

   NEXT: Go to next step 

3. CHECK CAN COMMUNICATION SYSTEM* 
   1. Check for DTC output. Refer to DIAGNOSIS SYSTEM [08/2015 - ] .

      Result

      Result	Proceed to
      CAN communication DTC is not output.	A
      CAN communication DTC is output.	B

      B → GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] 

      A: Go to next step 

4. CHECK FOR DTC* 
   1. Proceed to DTC Check / Clear. Refer to DTC CHECK / CLEAR [08/2015 - ] .
      RESULT
      
      

      Result	Proceed to
      DTC is not output.	A
      DTC is output.	B

      B → GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2015 - ]  

      A: Go to next step 

5. PROBLEM SYMPTOM CONFIRMATION 

   NEXT: Go to next step 

6. SYMPTOM SIMULATION 

   NEXT: Go to next step 

7. PROBLEM SYMPTOMS TABLE 
   1. Refer to Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] .

      NEXT: Go to next step 

8. CIRCUIT INSPECTION 

   NEXT: Go to next step 

9. REPAIR OR REPLACE 

   NEXT: Go to next step 

10. CONFIRMATION TEST 

    NEXT → END