Meter Illumination is Always Dark [08/2015 - ]: Procedure

1. Check if CAN communication DTCs are output. Refer to DIAGNOSIS SYSTEM [08/2015 - ] .

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

B → Refer to   7 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.
   MAIN BODY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Illumination Rate Info	Illumination rate information/0 ms. to 99.99 ms.	Value output according to ambient light level	-

   Result

   Result	Proceed to
   The output value changes according to the ambient light level (w/o Multi-information display).	A
   The output value changes according to the ambient light level (w/ Multi-information display).	B
   The output value does not change according to the ambient light level.	C

B → Refer to   4 

C → Refer to   6 

A: Go to next step 

1. Replace the meter circuit plate with a new or a known good one. Refer to DISASSEMBLY [08/2015 - ] .

   OK

   The operation of the combination meter sub-assembly returns to normal.

NG → Refer to   5 

OK → END 

1. Replace the combination meter sub-assembly with a new or a known good one. Refer to REMOVAL [08/2015 - ] .

   OK

   The operation of the combination meter sub-assembly returns to normal.

NG → Refer to   5 

OK → END