Fuel Receiver Gauge Malfunction [08/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter following menus: Body Electrical / Combination Meter / Active Test.
5. Perform the Active Test according to the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Fuel Meter Operation	Fuel receiver gauge	Empty, 1/2, Full	-

   OK

   Fuel receiver gauge indication is normal.

   RESULT
   
   

   Result	Proceed to
   OK	A
   NG (w/o Multi-information display)	B
   NG (w/ Multi-information display)	C

B → Refer to   5 

C → Refer to   7 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter following menus: Body Electrical / Combination Meter / Data List.
5. Read the Data List according to the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Fuel Input	Fuel input/Min.: 0, Max.: 127.5	10th segment comes on: 39.6 to 45	Unit: Liter
   		9th segment comes on: 35.9 to 39.6
   		8th segment comes on: 32.0 to 35.9
   		7th segment comes on: 27.8 to 32.0
   		6th segment comes on: 23.6 to 27.8
   		5th segment comes on: 19.4 to 23.6
   		4th segment comes on: 15.3 to 19.4
   		3rd segment comes on: 12.1 to 15.3
   		2nd segment comes on: 8.1 to 12.1
   		1st segment comes on: 5.1 to 8.1

   Result

   Result	Proceed to
   Fuel level displayed on the Techstream is almost the same as fuel receiver gauge indication.	A
   Fuel level displayed on the Techstream differs from the fuel receiver gauge indication (w/o Multi-information display).	B
   Fuel level displayed on the Techstream differs from the fuel receiver gauge indication (w/ Multi-information display).	C

B → Refer to   5 

C → Refer to   7 

A: Go to next step 

1. Disconnect the L27 and R11 connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L27-12 (L) - R11-2 (FS)	Always	Below 1 Ω
   L27-13 (ES 2) - R11-3 (FE)	Always	Below 1 Ω
   L27-12 (L) - Body ground	Always	10 kΩ or higher
   L27-13 (ES 2) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Remove the fuel sender gauge assembly. Refer to REMOVAL [08/2015 - ] .
2. Inspect the fuel sender gauge assembly. Refer to INSPECTION [08/2015 - ] .
   RESULT
   
   

   Result	Proceed to
   OK (w/o Multi-information display)	A
   OK (w/ Multi-information display)	B
   NG	C

B → Refer to   7 

C → Refer to   6 

A → Refer to   5