Entire Combination Meter does not Operate [08/2015 - ]: Procedure

1. Disconnect the L27 connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L27-11 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   L27-2 (IG+) - Body ground	Power switch off	Below 1 V
   	Power switch on (IG)	11 to 14 V
   L27-1 (B) - Body ground	Power switch off	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Sub-assembly)

   RESULT
   
   

   Result	Proceed to
   OK (w/o Multi-information display)	A
   OK (w/ Multi-information display)	B
   NG	C

B → Refer to   3 

C → REPAIR OR REPLACE HARNESS OR CONNECTOR 

A → Refer to   2